Scannists are always looking for better antennas. The right anttenna can make the difference between hearing your target or not. It is often said that the antenna is more important than the radio it is connected too. One can spend more money on the antenna system that the radio, it is that important. Even more important that the antenna itself can be the coax that connects it to the radio.
That all being said, sometimes there is a way to improve your antenna situation without breaking the bank. In this spirit let’s look at a couple rules that can be broken creatively to get a decent antenna solution at a reasonable price.
Let’s start at the top. With antennas elevation rules all. The higher it goes the better, well most of the time anyway. Does it have to be mounted on the roof however? It might work quite well in the attic. Attic installations can also save on other matters. You usually don’t need fancy mounting gear for attic antennas, just hang it from a rafter or set it on the floor. Antennas in the attic are well protected from the weather and you can do installations in the rain without getting wet.
If you live in an HOA then you might not be allowed rooftop antennas anyway so the attic might be the only way to go. It is not without its problems however. If you have a metal roof or other metallic structures above they would be a problem. Watch for metal backed insulation sheeting, HVAC hoses and other obstructions.
If you live in rental housing or a condo you might not even have the ability to use attic antennas at all. If this is the case then you are stuck with inside antennas. There are a couple things you still could do. Can you mount an antenna on a balcony or patio? How about putting a mobile magnet mount antenna on a refrigerator or air conditioner? Hang a rooftop type antenna from the ceiling or mount on the balcony? There are a lot of different things you can do when limited by space, rules or conditions.
When mounting an antenna on the roof or in the attic be sure to use quality feedline (coax). For scanners either 50 or 75 ohm coax works fine. Avoid the use of adapters as much as possible and try to use the shortest amount of coax as possible. Having 30 feet of coax coiled up in a corner will reduce the effectiveness of the antenna dramatically.
As always, if there are more questions you can ask your friendly (well sometimes grouchy) scanner expert here at ScannerMaster!
