Boxborough, MA – Scanner Master has sold and installed the equipment for a Rangecast monitoring system to the Boxborough, Massachusetts, Police Department. In this image you can see four BCT15X Bearcat Scanners mounted in a Scanner Master two-hole rack-mounting panel which is installed in the police department’s computer room at their station. The scanners are connected to a discone antenna mounted on the department’s tower and a Stridsberg multicoupler splits the feed to the four scanners while recovering loss with a small amplifier . A quad-core PowerSpec PC is connected to the scanners via a custom Rangecast Sound Hub which allows four scanners to simultaneously feed into one PC and upload to the Internet. The Boxborough Police use Rangecast to follow and record their department’s communications along with all surrounding local and State law enforcement. Rangecast is a powerful, easy-to-use and low-cost IP-based communications monitoring system. For more information on Rangecast visit Rangecast.com or contact Scanner Master.
Monthly Archives: April 2012
Show Off Your Shack! – Ken LaBelle (North Smithfield, RI)
(Fire/Rescue Captain Town of Lincoln, RI 15yrs on the job)
From: North Smithfield, RI
Owner: www.scanri.net
In the hobby for: 20+ years avid scanner listener
What does he like to listen to? Listen to mostly fire/ems but I do have local police.
Scanners
My scanners all have been purchased through Scanner Master. I have 6 Uniden 996t’s on my desk and a Motorola CDM 1250 UHF radio for fire buff club usage. One of the 6 scanners is dedicated for my website scanri.net. I use ProScan to stream to my followers on Radio Reference, ProScan, and the webserver site.
Antennas
The antennas are: (scanner) Antenna Specialist Mon-31, (UHF Radio) Comtelco 36” fiberglass 470-512, and there is a Ferret scanner antenna. (I am not using the Ferret at the moment due to it lacks reception in the UHF bands). The coax is all LMR400 with Amphenol connectors. The Mon-31 scanner antenna coax ties into a Stridsberg active 8-port multicoupler. I also have a Jim M75 pre-amp before the multicoupler that greatly increases my reception range. The UHF antenna connects to my remote mount Motorola CDM 1250 radio.
Multicoupler
The Stridsberg device connects to the 6 Uniden 996T scanners on my desk, a BC780 on my bedroom nightstand, and my Uniden 796d Scanner Master remote-head edition. The brain of the 796d is in my attic near my office and the head is located in the living room of my house on an end table. A 50’ lead of CAT5 cable connects the two. The scanners in the Spectrum Force desk mounts have “T” connectors on the coax feeds to each. I did this to minimize runs of coax along my walls to the desk. The last 2 open ports on the multicoupler are capped off with a BNC terminator caps for future use.
You will see a tan box mounted on the attic mounting wallboard. This is the power supply for the house security cameras. I have a DVR on the desk for the cameras and it is also connected to the Internet via the router. I use the scanners to monitor for my hobby and to alert me for breaking news for my photography business NRI Fire Photos that can be found at www.nrifirephotos.com.
Thanks for taking the time to view my “Shack”.
Ken
Learn how to Show off your Shack! – read more
Show Off Your Shack! – Scott Freiman (Tucson, AZ)
Learn how to Show off your shack! – read more
Shack owner: Scott Freiman
From: Tucson, AZ
In the hobby for: Over 35 years
What does he like to listen to? Police and SWL Broadcast
Shack consists of: (2) Uniden BCT15X scanners, Icom IC-R-75 receiver
(Also not pictured and spread throughout the house are a GRE PSR-700, Icom PCR-100 and several Uniden BC-3xx series scanners)
Show Off Your Shack! – Bristol, RI Emergency Dispatch Center
In honor of National Public Safety Telecommunicators Week
(April 8-14, 2012) here is the Town of Bristol, RI “Shack”.
Submitted and written by:
Rick Giannini (Twitter @rickgiannini)
Frequencies:
Fire Dispatch – 154.14500 – PL 114.8
Police Dispatch – 155.13000 – PL 114.8
Left Side run down
- DVD Recorder for prisoner movement
- VHS/DVD for dispatch on Duty
- 20 Channel Pelco DVR (Town Security CCTV IP Cams)
- 4 Channel DVR (small grey unit, going to be replace)
- 20 Channel CCT Switching Unit
- 20 Channel Sount Recorder
- 16 Channel DVR BPD CCTV
Right Side run down
- Digital Encrypted 800MHz Radio as Well as UHF Encrypted Radio (State EMA)
- Kalatel Camera controller CCTV BPD Campus Cameras
- Keltron Fire control panel radio box head end receiver
RI does not allow for new landline connections to local municipality for fire alarms
Bristol Mobile Command Center
We have a 65′ Mobile command center which can be deployed at key areas in town as a back up to dispatch with full capability of phone, fax, computer and radio in the event that the police station ever became incapacitated by disaster or other nature. We have a server and back-up on site, however, we also have a 100GB microwave uplink which updates a 3rd server located in another town building. The FD also has a dispatch center, however it is a computer and radio, with the Keltron Fire control panel. It serves as a tertiary dispatch center if needed, however the new fire station serves as the town’s EOC and was put into 24/7 use 2 months after opening due to a flood which brought the town to it’s knees 2 years ago. It was also used during Hurricane Irene, BFD took over dispatch for FD units and allowed the PD to focus on law enforcement.
Scanner 101 – Tips on picking and installing a Roof Top Antenna
Have you been putting off installing a roof top antenna for your scanner? A roof top antenna is the best way to increase your scanner’s range.
What antenna should you pick?
When selecting you should keep the following in mind:
What type of communication systems are you monitor? VHF, UHF and 700/800/900MHz so on… If the area is using the same type of communication system you may want to consider a single band antenna. If there is a mix I would recommend “wide band” antenna.
Mounting your antenna
When selecting antenna you want to keep in mind; how and where you’re going to mount it. So many options available from non-penetrating, tripod, and wall mount. Keep way from power lines and telephone/cable wires. The higher the better, be sure you clearing anything that would block signals such as chimes.
Coax Cable
Your antenna performance depends on great coax cable! We carry LMR-400 Coax cable which is a high-end low signal loss coax. When planning out your coax routes, be sure you have a little extra, but not too much. Shorter runs are always best. Keep this in mind: the old carpenter rule of thumb, measure twice, cut once!
Will you have multiple listening locations?
Depending on how many listening locations you have in mind, you will need a 4 Port or 8 Port Multicoupler. This should be placed somewhere in a central location in your home or office. I would recommend running LMR-400 Coax cable (no more than 100 feet) from the antenna to the Multicoupler. From the Multicoupler to the scanners I would recommend LMR-400 or RG-6 Coax (no more than 50 feet). Both of the multicouplers have a built in pre-amp to cut down on signal loss going to the monitoring locations.
Installing the antenna
If your pretty handy this can be something you can do on your own, with help from a friend. Just following instructions provided with the antenna. If heights are not you thing I would recommend hiring help.
Scanner Master is your one stop shop for your entire base scanner antenna needs – from antennas to coax to mounting gear! Spring is here; don’t keep putting it off! Make 2012 the year to upgrade your scanner’s reception.
Quick Links:
Not sure?
Give us a call at Scanner Master 1-800-SCANNER we can help you!